2011 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE

Remote Function Actuator (RFA) Module

REMOTE FUNCTION ACTUATOR (RFA) MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
B108A: 12 Start Button: Circuit Short To Battery REFER to STEERING COLUMN SWITCHES .
B10AB: 06 Remote Keyless Entry Synchronization: Algorithm Based Failure REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B10C6:01 Exterior Trunk Antenna: General Electrical Failure REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B10C6:13 Exterior Trunk Antenna: Circuit Open REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B10C7:01 Interior Trunk Antenna: General Electrical Failure REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10C7:13 Interior Trunk Antenna: Circuit Open REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10C8:01 Interior Centre Antenna: General Electrical Failure REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10C8:13 Interior Centre Antenna: Circuit Open REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10C9:01 Interior Front Antenna: General Electrical Failure REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10C9:13 Interior Front Antenna: Circuit Open REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D7:05 PATS Key: System Programming Failure REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D7:31 PATS Key: No Signal REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D8:51 PATS Key Less Than Minimum Programmed: Not Programmed REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D9:11 PATS Transponder: Circuit Short To Ground REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D9:12 PATS Transponder: Circuit Short To Battery REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D9:31 PATS Transponder: No Signal REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D9:87 PATS Transponder: Missing Message REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10DA: 51 PATS Target Identifier: Not Programmed REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10DA: 61 PATS Target Identifier: Signal Calculation Failure REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B113E: 11 External Boot/Trunk Release Switch: Circuit Short To Ground REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B11C6:01 Passenger Door External Antenna: General Electrical Failure REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B11C6:13 Passenger Door External Antenna: Circuit Open REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B11CA: 01 Driver Door External Antenna: General Electrical Failure REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B11CA: 13 Driver Door External Antenna: Circuit Open REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1219:11 Interior Boot/Trunk Release Switch: Circuit Short To Ground REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B121A: 11 Keypad Illumination Output: Circuit Short To Ground REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B121A: 15 Keypad Illumination Output: Circuit Short To Battery or Open REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B121B: 11 Keypad Input Switch: Circuit Short To Ground REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1381:11 Left Front Door Handle Proximity Sensor: Circuit Short To Ground REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1381:15 Left Front Door Handle Proximity Sensor: Circuit Short To Battery or Open REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1381:29 Left Front Door Handle Proximity Sensor : Signal Invalid REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1382:11 Right Front Door Handle Proximity Sensor: Circuit Short To Ground REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1382:15 Right Front Door Handle Proximity Sensor: Circuit Short To Battery or Open REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1382:29 Right Front Door Handle Proximity Sensor: Signal Invalid REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
P1571:12 Brake Switch: Circuit Short To Battery REFER to EXTERIOR LIGHTING .
U0140:87 Lost Communication With Body Control Module: Missing Message GO to PINPOINT TEST I .
U1000:00 Solid State Driver Protection Active - Driver Disabled: No Sub Type Information GO to PINPOINT TEST J .
U2100:55 Initial Configuration Not Complete: Not Configured CARRY OUT PMI  on the Remote Function Actuator (RFA) module. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test. If DTC U2100:55 is retrieved again, INSTALL a new RFA  module. REFER to REMOTE FUNCTION ACTUATOR (RFA) MODULE . TEST the system for normal operation.
U201F: 31 External Receiver: No Signal REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
U3000:49 Control Module: Internal Electronic Failure DIAGNOSE all other DTCs first. If no other DTCs are present, INSTALL a new RFA  module. REFER to REMOTE FUNCTION ACTUATOR (RFA) MODULE . TEST the system for normal operation.
U3003:62 Battery Voltage: Signal Compare Failure GO to PINPOINT TEST K .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.