2011 Ford Edge FWD V6-3.7LFACTORY OEM SERVICE PROCEDURE

Stepped Unlock Programming




Stepped Unlock Programming

Programming the Stepped Unlock Using an Remote Keyless Entry (RKE) Transmitter

1. With the ignition switch in the OFF position, press the LOCK and UNLOCK buttons on the Remote Keyless Entry (RKE) transmitter simultaneously for 4 seconds.
- The turn signals flash twice to indicate the mode change.


2. Repeat Step 1 to enable/disable the stepped unlocking feature.

Programming the Stepped Unlock Using the Instrument Cluster (IC) Message Center

1. With all the vehicle doors closed, turn the ignition key from the OFF to the ON position.

2. NOTE: Refer to the Owner's Literature for a complete list of the message center menus.
Access the locks menu within the setup menu in the message center.


3. Select remote unlock and use the left and right arrows to select all doors or drivers door first.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.