Keyless Entry Keypad Code Programming

Keyless Entry Keypad Code Programming

Remote Function Actuator (RFA) Module Keyless Entry Keypad Code Reset

NOTE: This procedure is for transferring the factory keyless entry keycode from the Body Control Module (BCM) and programming it into the Remote Function Actuator (RFA) module.

1. Carry out the keyless entry keypad code reset on the scan tool following the on-screen instructions.
- The keyless entry keypad code reset procedure is found on the scan tool under Toolbox>Body>Security.


Programming a Personal Entry Code and Keypad Association to Memory Features (If Equipped)

NOTE: The system allows 3 personal codes to be programmed.

NOTE: Multiple personal codes can be programmed in one step. When programming multiple codes in one step, each code must be programmed by entering each button within 5 seconds of each other. If 5 seconds elapse between any button press, programming mode is exited.

NOTE: If only a single personal code is desired or unable to program multiple codes in one step, each personal code can be programmed individually by repeating Steps 1-5 for each code desired.

1. Enter the factory set 5-digit keyless entry keypad code.

2. Within 5 seconds, press the 1/2 button on the keypad to activate the programming mode.

3. Enter the new personal 5-digit keyless entry keypad code. Each number must be entered within 5 seconds of each other.

4. After entering the new personal code, press a 6th button to program each new code.
- Pressing 1/2 stores the first personal code (if equipped with memory, this code is associated with driver 1 settings).

- Pressing 3/4 stores the second personal code (if equipped with memory, this code is associated with driver 2 settings).

- Pressing 5/6, 7/8 or 9/0 stores the third personal code, but does not associate the code with a memory setting.


5. The door locks lock and unlock to confirm the new code is programmed.

Erasing a Personal Entry Code

1. Enter the factory set 5-digit keyless entry keypad code.

2. Within 5 seconds, press the 1/2 button on the keypad and release.

3. Within 5 seconds, press and hold the 1/2 button for 2 seconds.

4. All personal codes are now erased and only the factory set 5-digit code works.