Autolock and Auto-Unlock Programming

Autolock and Auto-Unlock Programming

Programming the Autolock Feature Using the Keyless Entry Keypad

NOTE: The autolock feature can be activated or deactivated independently of the auto-unlock feature.

NOTE: The autolock feature also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to Information Bus.

1. Turn the ignition key to the OFF position and close all vehicle doors.

2. Enter the factory set 5-digit keyless entry keypad code.

3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press the 7/8 button.

4. Release the 7/8 button, then release the 3/4 button. The horn chirps once if the autolocks are disabled or twice (one short chirp followed by a honk) if the autolocks are enabled.

Programming the Autolock Feature Using the Instrument Cluster (IC) Message Center

NOTE: The autolock feature can be activated or deactivated independently of the auto-unlock feature.

NOTE: The autolock feature can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to Information Bus.

1. With all the vehicle doors closed, turn the ignition key from the OFF to the ON position.

2. NOTE: Refer to the Owner's Literature a complete list of the message center menus.
Access the locks menu within the setup menu in the message center.


3. Select autolock and use the left and right arrows to enable or disable the feature.

Programming the Auto-Unlock Feature Using the Keyless Entry Keypad

NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.

NOTE: The auto-unlock feature can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to Information Bus.

1. Turn the ignition key to the OFF position and close all vehicle doors.

2. Enter the factory set 5-digit keyless entry keypad code.

3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button, press and release the 7/8 button a second time.

4. Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.

Programming the Auto-Unlock Feature Using the Instrument Cluster (IC) Message Center

NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.

NOTE: The auto-unlock feature can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to Information Bus.

1. With all the vehicle doors closed, turn the ignition key from the OFF to the ON position.

2. NOTE: Refer to the Owner's Literature a complete list of the message center menus.
Access the locks menu within the setup menu in the message center.


3. Select auto-unlock and use the left and right arrows to enable or disable the feature.