Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Ford Edge AWD V6-3.7LFACTORY OEM SERVICE PROCEDURE
Power Trunk / Liftgate Control Module: Service and Repair
Liftgate/Trunk Module (LTM)
Removal and Installation
1. Remove the LH quarter trim panel.
2. Disconnect the 2 Liftgate/Trunk Module (LTM) electrical connectors.
3. Remove the 2 LTM (Liftgate/Trunk Module) retaining bolts and remove the LTM (Liftgate/Trunk Module).
- To install, tighten to 7 Nm (62 lb-in).
4. To install, reverse the removal procedure.
- Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization Programming and Relearning.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.