Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2011EDGE AWD V6-3.7LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTSERVICE AND REPAIRAUDIO DIGITAL SIGNAL PROCESSING (DSP) MODULE
2011 Ford Edge AWD V6-3.7L
Audio Digital Signal Processing (DSP) Module
2011 Ford Edge AWD V6-3.7LSECTION Audio Digital Signal Processing (DSP) Module
Audio Digital Signal Processing (DSP) Module
THX Sound
Sony Sound
Removal and Installation
All
1. NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
Upload the audio DSP (Digital Signal Processing) module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus Programming and Relearning.
2. Remove the subwoofer speaker. For additional information, refer to Speaker- Subwoofer Speaker - Subwoofer.
3. Disconnect the audio DSP (Digital Signal Processing) module electrical connectors.
THX sound
4. Remove the 4 screws and the audio DSP (Digital Signal Processing) module.
Sony sound
5. Remove the 3 screws the nut and the audio DSP (Digital Signal Processing) module.
All
6. To install, reverse the removal procedure.
- Download the configuration information to the audio DSP (Digital Signal Processing) module. For additional information, refer to PMI (Programmable Module Installation) in Information Bus. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.