2010 Ford Transit Connect Van CargoFACTORY OEM SERVICE PROCEDURE

DTC Chart

NOTE: Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous Memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC CHART

DTC Description Source Action
B2477 Module Configuration Failure
  • ABS module
  • Audio Control Module (ACM)
  • Generic Electronic Module (GEM)
  • Instrument Cluster (IC)
  • Parking Aid Module (PAM)
  • Restraints Control Module (RCM)
  • Tire Pressure Monitoring System (TPMS) module
 CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0602:00 Powertrain Control Module Programming Error: No Sub Type Information
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0605:00 Internal Control Module Read Only Memory (ROM  ) Error: No Sub Type Information
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1635:00 Tire/Axle Out Of Acceptable Range: No Sub Type Information
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1639:00 Vehicle ID Block Corrupted, Not Programmed: No Sub Type Information
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300:00 Internal Control Module Software Incompatibility: No Sub Type Information
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • ABS module
  • ACM 
  • IC 
  • Occupant Classification System Module (OCSM)
  • RCM 
  • TPMS  module
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2051 One or More Calibration Files Missing/Corrupt
  • RCM 
  • OCSM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • Speech Recognition Module (SRM)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information
  • SRM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2202:00 Invalid Configuration Data Received: No Sub Type Information
  • ABS module with stability control
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U3000:51 Control Module: Not Programmed
  • SRM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.