SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010TRANSIT CONNECT VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESMODULE CONFIGURATION SYSTEMDIAGNOSIS AND TESTINGMODULE CONFIGURATIONPRINCIPLES OF OPERATIONAS-BUILT DATA
2010 Ford Transit Connect Van Cargo

As-Built Data

2010 Ford Transit Connect Van CargoSECTION As-Built Data

As-Built data is a VIN  -specific module configuration record. During vehicle build, the configuration from all modules is downloaded and stored in the As-Built database. As-Built data does not reflect customer preference items that have been changed from the default state. These items need to be changed using programmable parameters after the module is configured.

NOTE: It is not necessary to obtain As-Built data unless directed to do so by the scan tool. This data may be accessed from the technician service publication website.
MODULE CONFIGURATION AND PARAMETER CHART

Module Module Address Requires PMI  Reprogram/ Flash Capable Requires Adaptive Learning or Calibration Available Programmable Parameters
ABS module 760 Yes No No None
Audio Control Module (ACM) 727 Yes No No None
Generic Electronic Module (GEM) 726 Yes No No
  • Cargo unlock settings
  • General unlock settings
  • Rear door reverse cycling
Instrument Cluster (IC) 720 Yes No No
  • Door ajar
  • Voice recognition module
Occupant Classification System Module (OCSM) 765 No No
  • Seat weight sensor re-zero
 None
Parking Aid Module (PAM) B2 Yes No No None
PCM 7E0 Yes Yes
  • Adaptive airflow
  • Idle speed
  • Refueling event
  • Fuel trim
  • Axle ratio
  • Octane adjust
  • Tire size
Restraints Control Module (RCM) 737 Yes No
  • Seat weight sensor re-zero
 None
Speech Recognition Module (SRM) 772 Yes No No None
Tire Pressure Monitoring System (TPMS) module 751 Yes No No None
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.