Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
What's New in this Information
2010 Ford Taurus SEL, FWDSECTION What's New in this Information
The following is a list of changes to this service information for 2010:
- Fusion and Milan with 2.5L 4V engine
- Fusion with 3.5L 4V engine option
- Fusion and Milan with 2.5 and 3.0L engines equipped 190-pin PCM
- Fusion and Milan with 3.0L engines are equipped with universal heated oxygen sensor (HO2S)
- Fusion and Milan with 3.0L engines are equipped with 3-pin Hall-effect type camshaft position (CMP) sensor
- New On Board Diagnostic (OBD) Drive Cycle
- Secondary AIR system discontinued
- Flex, MKS and Taurus with option of new 3.5L GTDI engine
- MKT equipped with 3.5L GTDI or 3.7L engine
- Transit Connect with 2.0L engine
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.