2010 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE

Starting System DTCS

DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
P0615:11 Start Relay Circuit: Short to Ground Go To PINPOINT TEST E .
P0615:12 Start Relay Circuit: Short to Battery Go To PINPOINT TEST E .
P0615:13 Start Relay Circuit: Circuit Open Go To PINPOINT TEST E .
All other DTCs - REFER to the DTC Chart in MULTIFUNCTION ELECTRONIC MODULES .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.