Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | N.m | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Camshaft Position (CMP) sensor bolts | 10 | - | 89 | ||
| Catalyst Monitor Sensor (CMS)(1) | - | - | - | ||
| Crankshaft Position (CKP) sensor bolt | 10 | - | 89 | ||
| Cylinder Head Temperature (CHT) sensor | 10 | - | 89 | ||
| Fuel Rail Pressure (FRP) sensor | 33 | 24 | - | ||
| Heated Oxygen Sensor (HO2S)(1) | - | - | - | ||
| Heat shield bolt and nut | 10 | - | 89 | ||
| Knock Sensor (KS) bolt | 20 | - | 177 | ||
| Turbocharger Boost Pressure (TCBP)/Charge Air Cooler Temperature (CACT) | 3 | - | 27 | ||
| Manifold Absolute Pressure (MAP)/Intake Air Temperature 2 (IAT2) | 6 | - | 53 | ||
| Mass Air Flow (MAF) sensor screws | 2 | - | 18 | ||
| PCM nuts | 8 | - | 71 | ||
| Throttle Position (TP) sensor | 3 | - | 27 | ||
| Variable Camshaft Timing (VCT) oil control solenoid bolts | 10 | - | 89 | ||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.