Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Ford Focus L4-2.0LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
a No. 3 Journal - Supported by No. 1 and No. 5 journals.
ROD BEARING CAP
Using the original connecting rod cap bolts, install the connecting caps and bolts.
Tighten the bolts in 2 stages.
Stage 1: Tighten to 29 Nm (21 lb-ft).
Stage 2: Tighten an additional 90 degrees.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.