Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Ford Escape 2WD L4-2.5LFACTORY OEM SERVICE PROCEDURE
Computers and Control Systems: Technical Service Bulletins
- Recalls
- Customer Interest
- Emissions - MIL ON/Multiple EVAP DTC's Set
- A/T Controls - Harsh 1-2 Shift/2-3 Shift Flare
- Engine Controls - MIL ON/Multiple DTC's Set
- Emissions - Driveability Issues With/Without/MIL/DTC's
- Engine - Hard Start/Rough Idle/DTC's P0016/P052A/B
- A/T Control - Harsh Shift/Upshift Flare/Harsh Engagement
- Engine, A/T Controls - MIL/Stuck In 5th Gear/DTC's Set
- Engine Controls - MIL ON/DTC P2135/P2111/P0122
- By Symptom
- Customer Interest
- Emissions - MIL ON/Multiple EVAP DTC's Set
- A/T Controls - Harsh 1-2 Shift/2-3 Shift Flare
- Engine Controls - MIL ON/Multiple DTC's Set
- Emissions - Driveability Issues With/Without/MIL/DTC's
- Engine - Hard Start/Rough Idle/DTC's P0016/P052A/B
- A/T Control - Harsh Shift/Upshift Flare/Harsh Engagement
- Engine, A/T Controls - MIL/Stuck In 5th Gear/DTC's Set
- Engine Controls - MIL ON/DTC P2135/P2111/P0122
- Driveability
- Hard Shifting
- Incorrect gear selection
- Leaks
- No shift/Incorrect gear engagement
- Recalls
- Slipping
- Sticking/Binding
- Customer Interest
- All Technical Service Bulletins
- Emissions - MIL ON/Multiple EVAP DTC's Set
- A/T Controls - Harsh 1-2 Shift/2-3 Shift Flare
- Engine Controls - MIL ON/Multiple DTC's Set
- Emissions - Driveability Issues With/Without/MIL/DTC's
- Engine - Hard Start/Rough Idle/DTC's P0016/P052A/B
- A/T Control - Harsh Shift/Upshift Flare/Harsh Engagement
- Engine, A/T Controls - MIL/Stuck In 5th Gear/DTC's Set
- Campaign - ECM Update For A/T Durability
- A/T 6F35 - DTC P0720/P0722/Harsh Engagement/Shifts
- Engine Controls - MIL ON/DTC P2135/P2111/P0122
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
