2009 Ford Flex SEFACTORY OEM SERVICE PROCEDURE

Material Specifications

MATERIAL SPECIFICATIONS

Item Specification Fill Capacity
Dye-Lite® ATF/Power Steering Fluid Leak
Detection Dye
164-R3701 (Rotunda)
- -
MERCON® V Automatic Transmission Fluid
XT-5-QM (or XT-5-QMC) (US); CXT-5-LM12 (Canada)
MERCON® V 9.5L (10 qt)
Early build (1)
Motorcraft® MERCON® LV Automatic
Transmission Fluid
XT-10-QLVC
MERCON® LV 9.5L (10 qt)
Late build (2)
Multi-Purpose Grease
XG-4 and/or XL-5
ESB-M1C93-B -
(1) Built before 1/19/2009.
(2) Built on of after 1/19/2001.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.