Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Ford Flex SEFACTORY OEM SERVICE PROCEDURE
General Specifications
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| 6F50 Transaxle Weight | 100 kg (220 lb) |
| Transmission Fluid | |
| The use of any transmission fluid other than what is recommended for this transaxle will cause transaxle damage. Refer to the MATERIAL specification and/or the transmission fluid level indicator for the correct fluid. | |
|
NOTE:
Do not mix Mercon® V or Mercon® LV transmission fluid. This may cause erratic shift feel, erratic shift timing and/or transmission failure.
|
|
|
NOTE:
Do not use water-based cleaners to clean or flush the transmission fluid cooler tubes or transmission damage will occur. Mineral spirits can be used to clean the transmission fluid cooler tubes, providing the transmission fluid cooler tubes are flushed with clean transmission fluid and blown dry with shop air. Use only clean transmission fluid designated for this transaxle and torque converter being serviced.
|
|
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
