Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Ford Flex SEFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Accessory Protocol Interface Module (APIM) | Center console. See Figure. |
| Ambient Lighting Module | Center console. See Figure. |
| Anti-Lock Brake System (ABS) Module | Left rear of engine compartment. See Figure. |
| Auxiliary Blower Control Module | Left rear quarterpanel. See Figure. |
| DC/AC Inverter Module | Base of right "D" pillar. See Figure. |
| Electronic Throttle Control (ETC) | Top right rear of engine. See Figure. |
| Front Blower Motor Speed Controller | Right side of HVAC unit. See Figure. |
| Fuel Pump Control Module | Right "C" pillar. See Figure. |
| Fuel Tank Unit | In fuel tank. See Figure. |
| Heated Seat Module (Front) | Under front passenger's seat. See Figure. |
| Heated Seat Module (Rear) | Center console. See Figure. |
| HVAC Module | Center of dash. See Figure. |
| Liftgate/Trunk Module (LTM) | Left "D" pillar. See Figure. |
| Occupant Classification System Module (OCSM) | Under front passenger's seat. See Figure. |
| Parking Aid Module (PAM) | Right "C" pillar. See Figure. |
| Powertrain Control Module (PCM) | Rear of engine compartment. See Figure. |
| Restraints Control Module (RCM) | Center console. See Figure. |
| Roof Opening Panel Module | Center front of roof. See Figure. |
| Seat Module (DSM) (Driver) | Under driver's seat. See Figure. |
| Steering Angle Sensor Module (SASM) | Top of steering column. See Figure. |
| Trailer Brake Control (TBC) Module | Left side of dash. See Figure. |
| 4X4 Control Module | Right kick panel. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
