Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Ford Expedition 4WDFACTORY OEM SERVICE PROCEDURE
Engine Cooling Systems DTCS
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| P0217 | Engine Coolant Over Temperature Condition | Go To PINPOINT TEST B . |
| P1285 | Cylinder Head Over Temperature Condition | Go To PINPOINT TEST B . |
| P1299 | Cylinder Head Over Temperature Protection Active | Go To PINPOINT TEST B . |
| P0125 | Insufficient Coolant Temperature For Closed Loop Fuel Control | Go To PINPOINT TEST C . |
| P0128 | Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) | Go To PINPOINT TEST C . |
| All Other DTCs | - | Refer to the INTRODUCTION - GASOLINE MODELS article. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.