2009 Ford Edge Sport, AWDFACTORY OEM SERVICE PROCEDURE

Inspection and Verification

This information provides step-by-step module configuration procedures. Carry out the Programmable Module Installation  when another article directs to carry out configuration or when DTCs from the below list are present:

DTC CHART

DTC Description Source Action
B2477 Module Configuration Failure
  • ABS module
  • Audio control module (ACM)
  • Audio digital signal processing (DSP) module
  • Dual climate controlled seat module (DCSM)
  • Driver seat module (DSM)
  • Instrument cluster (IC)
  • Parking aid module (PAM)
  • Rear entertainment module (RETM)
  • Restraints control module (RCM)
  • Satellite digital audio receiver system (SDARS) module
  • Smart junction box (SJB)
 CARRY OUT PMI. REFER to Programmable Module Installation .
B2477 Module Configuration Failure
  • Accessory protocol interface module (APIM)
 REFER to INFORMATION AND ENTERTAINMENT SYSTEMS article to carry out the APIM Programming And Software Level Check.
B2900 VIN Mismatch
  • 4X4 control module
 REFER to FOUR WHEEL DRIVE (4WD) SYSTEMS article.
P0602 Powertrain Control Module Programming Error
  • PCM
 CARRY OUT PMI. REFER to Programmable Module Installation .
P0605 Internal Control Module Read Only Memory (ROM) Error
  • PCM
 CARRY OUT PMI. REFER to Programmable Module Installation .
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
 CARRY OUT PMI. REFER to Programmable Module Installation .
U0300 Internal Control Module Software Incompatibility
  • PCM
 CARRY OUT PMI. REFER to Programmable Module Installation .
U201A:51 Control Module Main Calibration Data: Missing Calibration list CARRY OUT PMI. REFER to Programmable Module Installation .
U2050 No Application Present
  • ABS module
  • ACM
  • DCSM
  • DSM
  • DSP module
  • Headlamp control module (HCM)
  • HVAC module
  • IC
  • Liftgate/trunk module (LTM)
  • Occupant classification system module (OCSM)
  • PCM
  • RCM
  • RETM
  • SDARS module
  • SJB
  • Steering angle sensor module (SASM)
  • 4X4 control module
 CARRY OUT PMI. REFER to Programmable Module Installation .
U2050 No Application Present
  • APIM
 REFER to INFORMATION AND ENTERTAINMENT SYSTEMS article to carry out the APIM Programming And Software Level Check.
U2051 One or More Calibration Files Missing / Corrupt
  • ABS module
  • ACM
  • DSP module
  • HVAC module
  • IC
  • LTM
  • PCM
  • RCM
  • 4X4 control module
 CARRY OUT PMI. REFER to Programmable Module Installation .
U2051 One or More Calibration Files Missing / Corrupt
  • PAM
 INSTALL a new PAM. REFER to PARKING AID article.
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • ACM (late build)
  • Audio DSP module
 CARRY OUT PMI. REFER to Programmable Module Installation .
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • APIM
 CARRY OUT PMI. REFER to Accessory Protocol Interface Module (APIM) Programming .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information
  • ACM (late build)
  • Audio DSP module
 CARRY OUT PMI. REFER to Programmable Module Installation .
U2101:00 Control Module Configuration Incompatible: No Sub Type information
  • APIM
 CARRY OUT APIM programming. REFER to Accessory Protocol Interface Module (APIM) Programming .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.