2008 Ford Taurus AWD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Piston Ring, Engine

Piston ring end gap - compression (top, gauge diameter) 0.15-0.25 mm (0.0059-0.0098 in)
Piston ring end gap - compression (bottom, gauge diameter) 0.30-0.55 mm (0.0118-0.0216 in)
Piston ring end gap - oil ring (steel rail, gauge diameter) 0.15-0.45 mm (0.0059-0.0177 in)
Piston ring groove width - compression (top) 1.230-1.25 mm (0.0484-0.0492 in)
Piston ring groove width - compression (bottom) 1.530-1.55 mm (0.0602-0.0610 in)
Piston ring groove width - oil ring 2.53-2.55 mm (0.0996-0.1003 in)
Piston ring width - upper comp ring 1.17-1.19 mm (0.0460-0.0468 in)
Piston ring width - lower comp ring 1.47-1.49 mm (0.0578-0.0586 in)
Piston ring-to-groove clearance (upper and lower compression rings) 0.040-0.080 mm (0.0015-0.0031 in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.