Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Mustang V6-4.0LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
Connecting Rod Nuts
NOTE: New nuts and bolts must be used for reassembly.
First pass 20 Nm (15 lb-ft).
Final pass Tighten an additional 90°
Connecting Rod
Pin bore diameter 23.958-23.976 mm (0.943-0.944 in)
Length (center-to-center) 145.965-146.035 mm (5.747-5.749 in)
Maximum allowed bend mm (0.0005 in) per 25.4 mm (1.000 in)
Maximum allowed twist 0.038 mm (0.0015 in) per 25.4 mm (1.000 in)
Bearing bore diameter 56.82 mm-56.84 mm (2.237 in-2.238 in)
Bearing clearance-to-crankshaft 0.022-0.064 mm (0.0008-0.0025 in)
Side clearance 0.092-0.268 mm (0.0036-0.0106 in)
NOTE: New nuts and bolts must be used for reassembly.
First pass 20 Nm (15 lb-ft).
Final pass Tighten an additional 90°
Connecting Rod
Pin bore diameter 23.958-23.976 mm (0.943-0.944 in)
Length (center-to-center) 145.965-146.035 mm (5.747-5.749 in)
Maximum allowed bend mm (0.0005 in) per 25.4 mm (1.000 in)
Maximum allowed twist 0.038 mm (0.0015 in) per 25.4 mm (1.000 in)
Bearing bore diameter 56.82 mm-56.84 mm (2.237 in-2.238 in)
Bearing clearance-to-crankshaft 0.022-0.064 mm (0.0008-0.0025 in)
Side clearance 0.092-0.268 mm (0.0036-0.0106 in)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
