Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Mustang V6-4.0LFACTORY OEM SERVICE PROCEDURE
Spark Plug: Service and Repair
SPARK PLUGS
Exploded View

Special Tool(s)

Removal
1. CAUTION: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
NOTE: Spark plug wires must be connected to the correct spark plug.
Using the special tool, remove the spark plug wires from the spark plugs using a twisting motion.

2. CAUTION: Only use hand tools when removing or installing the spark plugs, or damage may occur to the cylinder head or spark plug.
NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.
Remove the 6 spark plugs.
Installation
1. CAUTION: Only use hand tools when removing or installing the spark plugs, or damage may occur to the cylinder head or spark plug.
Install the 6 spark plugs.
- Tighten to 17 Nm (13 lb-ft).
2. Apply silicone brake caliper grease and dielectric compound to the inside of the spark plug wire-to-boots.
3. NOTE: Make sure the spark plug boots are positioned so that the spark plug wires do not contact the exhaust manifold, or any sharp edges.
Connect the 6 spark plug wires to the spark plugs.
Exploded View
Special Tool(s)
Special Tool(s):
Removal
1. CAUTION: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
NOTE: Spark plug wires must be connected to the correct spark plug.
Using the special tool, remove the spark plug wires from the spark plugs using a twisting motion.
2. CAUTION: Only use hand tools when removing or installing the spark plugs, or damage may occur to the cylinder head or spark plug.
NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.
Remove the 6 spark plugs.
Installation
1. CAUTION: Only use hand tools when removing or installing the spark plugs, or damage may occur to the cylinder head or spark plug.
Install the 6 spark plugs.
- Tighten to 17 Nm (13 lb-ft).
2. Apply silicone brake caliper grease and dielectric compound to the inside of the spark plug wire-to-boots.
3. NOTE: Make sure the spark plug boots are positioned so that the spark plug wires do not contact the exhaust manifold, or any sharp edges.
Connect the 6 spark plug wires to the spark plugs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
