2008 Ford Mustang V6-4.0LFACTORY OEM SERVICE PROCEDURE

Catalyst Monitor Sensor

CATALYST MONITOR SENSOR

Special Tool(s)


Special Tool(s):

Factory service manual diagram





Factory service manual diagram





Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the catalyst monitor sensor electrical connector.

3. NOTE: If necessary, lubricate the catalyst monitor sensor with lock lubricant to aid in removal.

Using the special tool, remove the catalyst monitor sensor.
- To install, tighten to 48 Nm (35 lb-ft).


Factory service manual diagram





4. To install, reverse the removal procedure.
- Apply a light coat of anti-seize lubricant to the threads of the catalyst monitor sensor before installing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.