2008 Ford Focus L4-2.0LFACTORY OEM SERVICE PROCEDURE

Interior Lighting Module: Service and Repair

AMBIENT LIGHTING MODULE


Factory service manual diagram





Removal and Installation
1. Remove the center console finish panel.

2. NOTE: The ambient lighting module is mounted under the bottom of the floor console finish panel cup holder.

Remove the 2 screws and the ambient lighting module.
- Disconnect the electrical connector.

3. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.