Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Explorer 4WD V8-4.6LFACTORY OEM SERVICE PROCEDURE
Fuel Tank Pressure Sensor: Service and Repair
FUEL TANK PRESSURE SENSOR

Removal and Installation
WARNING:
- When working on or near the evaporative emission (EVAP) system, disconnect the battery ground cable from the battery. The EVAP system contains fuel vapor and condensed fuel vapor, so an electrical spark may cause a fire or explosion. Failure to follow this instruction may result in serious personal injury.
- Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Remove the evaporative emission (EVAP) canister.
2. Remove the fuel tank shield from the fuel tank.
3. Disconnect the fuel tank pressure (FTP) sensor electrical connector.
4. Disconnect the 3 FTP sensor and tube assembly quick connect couplings from the fuel pump module and the vapor vent valves.
5. Remove the FTP sensor and tube assembly.
6. To install, reverse the removal procedure.
7. Leak test the EVAP system.
8. Carry out the evaporative emission repair verification drive cycle.
Removal and Installation
WARNING:
- When working on or near the evaporative emission (EVAP) system, disconnect the battery ground cable from the battery. The EVAP system contains fuel vapor and condensed fuel vapor, so an electrical spark may cause a fire or explosion. Failure to follow this instruction may result in serious personal injury.
- Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Remove the evaporative emission (EVAP) canister.
2. Remove the fuel tank shield from the fuel tank.
3. Disconnect the fuel tank pressure (FTP) sensor electrical connector.
4. Disconnect the 3 FTP sensor and tube assembly quick connect couplings from the fuel pump module and the vapor vent valves.
5. Remove the FTP sensor and tube assembly.
6. To install, reverse the removal procedure.
7. Leak test the EVAP system.
8. Carry out the evaporative emission repair verification drive cycle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
