Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Explorer 4WD V8-4.6LFACTORY OEM SERVICE PROCEDURE
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR


Removal and Installation
1. With vehicle in NEUTRAL, position it on a hoist.
2. Remove the accessory drive belt.
3. Disconnect the A/C compressor coil electrical connector.
4. Detach the battery cable retainer from the A/C compressor stud bolts.
5. Remove the nut and detach the A/C tube bracket.
- To install, tighten to 10 Nm (89 lb-in).
6. Remove the stud bolts and position the A/C compressor aside.
- To install, tighten to 25 Nm (18 lb-ft).
7. Disconnect the crankshaft position (CKP) sensor electrical connector.
8. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).
9. To install, reverse the removal procedure.
Removal and Installation
1. With vehicle in NEUTRAL, position it on a hoist.
2. Remove the accessory drive belt.
3. Disconnect the A/C compressor coil electrical connector.
4. Detach the battery cable retainer from the A/C compressor stud bolts.
5. Remove the nut and detach the A/C tube bracket.
- To install, tighten to 10 Nm (89 lb-in).
6. Remove the stud bolts and position the A/C compressor aside.
- To install, tighten to 25 Nm (18 lb-ft).
7. Disconnect the crankshaft position (CKP) sensor electrical connector.
8. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).
9. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
