Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Explorer 4WD V8-4.6LFACTORY OEM SERVICE PROCEDURE
Auxiliary Climate Control Assembly
AUXILIARY CLIMATE CONTROL ASSEMBLY
Removal and Installation
1. Remove the overhead console. Console - Overhead
2. Remove the 2 screws.
3. Remove the bezel.
4. Remove the auxiliary climate control assembly.
5. To install, reverse the removal procedure.
Removal and Installation
1. Remove the overhead console. Console - Overhead
2. Remove the 2 screws.
3. Remove the bezel.
4. Remove the auxiliary climate control assembly.
5. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.