2008 Ford Explorer 4.0 E, AWDFACTORY OEM SERVICE PROCEDURE

Keyless Entry Keypad Code Programming

NOTE: A maximum of 3 personal entry codes can be programmed into the vehicle. The personal entry codes can be associated with up to two memory seat/adjustable pedal settings.
  1. Enter the permanent factory keyless entry keypad code.
  2. Press the 1/2 button within 5 seconds to activate the programming mode. Holding the 1/2 button for more than 2 seconds after activation erases all the stored customer codes. The existing codes do not need to be erased to program a new code.
  3. Within 5 seconds, enter the new 5-digit keyless entry keypad code.
  4. Press the 1/2, 3/4, or 5/6 to indicate which of the 3 personal entry code positions is to be programmed.
  5. The door locks lock and unlock to confirm the new code is programmed.
  6. To program an additional personal entry code, repeat Steps 2 through 4.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.