Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Hood release handle bolt | 9 | - | 80 |
| Steering column reinforcement cover bolts | 9 | - | 80 |
| Steering column shaft dash seal bolts | 12 | 9 | - |
| Steering column shaft-to-steering column bolt | 30 | 22 | - |
| Steering column shaft-to-steering gear bolt | 30 | 22 | - |
| Steering column shroud screws | 2 | - | 18 |
| Steering column support bracket-to-instrument panel nuts | 30 | 22 | - |
| Steering wheel bolt | 40 | 30 | - |
| Tilt lever screw | 6 | - | 53 |
| Upper steering column shaft-to-lower steering column shaft bolt | 48 | 35 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.