Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Stability/Traction Control Switch: Notes
Unlike the standard anti-lock control system the traction control system, ESC system and RSC® system can all be deactivated (at the same time) by the driver through the stability/traction control switch. The switch is hard-wired to the IC and when pressed sends a ground signal to the IC. The IC then sends a message over the HS-CAN bus indicating that the driver has requested that the system be deactivated and illuminates the stability/traction control indicator "sliding-car icon". After received this message, the ABS module and PCM will ignore any stability or traction events until the driver presses the switch again, the ignition key is cycled or the vehicle speed reaches or exceeds 70 km/h (43 mph). Once the vehicle speed reaches or exceeds 70 km/h (43 mph), the stability control system will re-activate but the indicator will remain illuminated.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
