2008 Ford Edge AWD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Power Trunk / Liftgate Control Module: Service and Repair

LIFTGATE/TRUNK MODULE (LTM)

Removal and Installation


Factory service manual diagram





1. Remove the power liftgate motor assembly.
2. Remove the LTM.
- Disconnect the electrical connectors and remove the 3 bolts.
- To install, tighten to 9 Nm (80 lb-in).


Factory service manual diagram





3. To install, reverse the removal procedure.
- Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization. Programming and Relearning
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.