2008 Ford Crown Victoria Police InterceptorFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Front Safety Belts 
D-ring bolt 40 30 -
Safety belt anchor bolt 40 30 -
Safety belt buckle nut (driver and passenger) 40 30 -
Safety belt retractor and pretensioner bolt 40 30 -
Safety belt shoulder height adjuster bolts 40 30 -
Seat track-to-floor bolts 25 18 -
Seat track-to-floor nut, inboard 80 59 -
Seat track-to-floor nut, outboard 25 18 -
Side impact sensor bolts 12 - 106
Rear Safety Belts 
Center safety belt retractor bolt 40 30 -
Child safety seat tether anchor bolt 25 18 -
D-ring bolt 40 30 -
Lower anchors and tethers for children bolt 18 - 159
Rear seat backrest nut 55 41 -
Safety belt anchor bolt 55 41 -
Safety belt buckle nut 55 41 -
Safety belt retractor bolt 40 30 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.