2007 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE

Overdrive Servo: Disassembly

  1. Remove the overdrive servo piston return spring.
  2. Fig 1: Overdrive Servo Piston Return Spring
    GF0020409Courtesy of FORD MOTOR CO.
  3. Remove the overdrive servo piston and rod assembly.
  4. Fig 2: Overdrive Servo Piston & Rod Assembly
    GF0020410Courtesy of FORD MOTOR CO.
  5. Remove the servo piston seal.
  6. Fig 3: Locating Servo Piston Seal
    GF0020411Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.