Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
External Controls
| Item | Part Number | Description |
|---|---|---|
| 1 | 7E395 | Selector lever cable |
| 2 | 7A256 | Manual control lever |
| 3 | 7H181 | Selector lever cable clip |
| 4 | - | Steering column lever |
| Item | Part Number | Description |
|---|---|---|
| 1 | 7E395 | Selector lever cable |
| 2 | 3F719 | Ignition/shifter interlock cable |
| 3 | 7K004 | Transaxle range selector lever and housing |
| 4 | - | Steering column lock assembly |
| 5 | - | Data link connector |
| 6 | 7H181 | Selector lever cable clip |
| 7 | 7A256 | Manual control lever |
The transaxle shift control linkage consists of:
- a steering column or floor-mounted transaxle range selector lever.
- a shift cable connecting the steering column to the transaxle range selector lever.
- an ignition/shifter interlock cable on floor-shift vehicles which connects the transaxle range selector lever to the steering column lock assembly.
- an ignition/shift lock actuator that is integral to the ignition/shifter interlock cable.
The ignition/shifter interlock cable:
- locks the transaxle range selector lever in the PARK position when the ignition switch is in the lock position.
- requires the transaxle range selector lever to be in the PARK position to turn the ignition switch to the lock position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.