2007 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE

Steering Column: Installation

Vehicles with console shift 

  1. Position the steering column and connect the shift lock actuator.
  2. Fig 1: Locating Shift Interlock Actuator
    GF0020647Courtesy of FORD MOTOR CO.

    Vehicles with column shift 

  3. Position the steering column and connect the shift cable.
  4. Fig 2: Locating Shift Cable
    GF0020646Courtesy of FORD MOTOR CO.
  5. Position transmission range selector lever cable, install the bolt and connect the transmission range selector lever cable.
  6. Fig 3: Locating Transmission Range Selector Lever Cable And Bolt
    GF0020645Courtesy of FORD MOTOR CO.
  7. Connect the brake shift interlock electrical connector.
  8. Fig 4: Locating Brake Shift Interlock Electrical Connector
    GF0020644Courtesy of FORD MOTOR CO.

    All vehicles 

  9. Position the steering column and the steering column absorber.
    • Install the 4 nuts and tighten to 11 Nm (8 lb-ft).
  10. Fig 5: Locating Lower Steering Column Nut
    GF0020643Courtesy of FORD MOTOR CO.
  11. Attach the steering column coupling to the steering column and install the bolt.
    • Tighten to 25 Nm (18 lb-ft).
  12. Position the wiring harness and attach the retainer to the steering column.
  13. Fig 6: Locating Wiring Harness Retainer
    GF0020641Courtesy of FORD MOTOR CO.
  14. Connect the steering column wiring harness.
    1. Connect the steering column wiring harness electrical connector.
    2. Attach the wiring harness retainer to the steering column.
  15. Fig 7: Identifying Steering Column Wiring Harness Electrical Connector And Wiring Harness Retainer
    GF0020648Courtesy of FORD MOTOR CO.
  16. Position the ignition switch electrical connector and install the bolt.
  17. Fig 8: Locating Ignition Switch Electrical Connector Bolt
    GF0020639Courtesy of FORD MOTOR CO.
  18. Install the instrument panel reinforcement support bar.
    1. Position the reinforcement bar, install the bolts and tighten to 15 Nm (11 lb-ft).
    2. Position the data link connector and install the screws.
  19. Position the instrument panel lower steering column cover and install the 2 screws.
  20. Repower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.