Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location |
|---|---|
| Air Bag Sliding Contact | Near bottom of steering column. See Figure. |
| AX4S/4F50N Transmission | Left rear of engine. See Figure. |
| Battery | Left front corner of engine compartment. See Figure. |
| Blower Motor Resistor Assembly | In dash, below center of glove box. See Figure. |
| Data Link Connector (DLC) | Mounted on dash, below steering column. See Figure. |
| Electronic Compass | On rearview mirror. See Figure. |
| Engine Cooling Fan Resistor | Near electric cooling fans. See Figure. |
| Generator | Right rear of engine compartment. See Figure. |
| Heated Positive Crankcase Ventilation (PCV) Valve | Top right side of engine. See Figure. |
| Horn | Lower left front of engine compartment. See Figure. |
| Ignition Transformer Capacitor 1 | Attached to ignition coil. See Figure. |
| Right Safety Belt Assembly | Under passenger seat. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.