Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G100 | Left side of engine compartment. See Figure. |
| G101 | Left side of engine, above starter motor. See Figure. |
| G102 | Right rear of engine compartment. See Figure. |
| G103 | Right rear side of engine compartment. See Figure. |
| G103 | Right rear side of engine compartment. See Figure. |
| G104 | Right front side of engine compartment. See Figure. |
| G105 | Right front side of engine compartment. See Figure. |
| G106 | Behind right side of front bumper, near forward crash sensor. See Figure. |
| G107 | Top left side of engine compartment. See Figure. |
| G108 | Top left side of engine compartment. See Figure. |
| G200 | Behind center of dash. See Figure. |
| G201 | Behind center of dash. See Figure. |
| G202 | At base of left "A" pillar. See Figure. |
| G203 | At base of left "A" pillar. See Figure. |
| G204 | At base of right "A" pillar. See Figure. |
| G205 | At base of right "A" pillar. See Figure. |
| G300 | Left side of luggage compartment, behind lining. See Figure. |
| G301 | Left side of luggage compartment, behind lining. See Figure. |
| G302 | Right side of luggage compartment, behind lining. See Figure. |
| G303 | Right side of luggage compartment, behind lining. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.