Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Warning Devices
INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1353 | Ignition Key-In Circuit Open | Go to Pinpoint Test A . |
| B236A | Chime Output Circuit Open | INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER article. TEST the system for normal operation. |
| B2903 | Chime Output Circuit Short to Battery | INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER article. TEST the system for normal operation. |
| B2940 | Chime Output Circuit Short to Ground | INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER article. TEST the system for normal operation. |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES article. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.