2007 Ford Fusion S, AutomaticFACTORY OEM SERVICE PROCEDURE

Wiper/Washer Systems

SMART JUNCTION BOX (SJB) WIPER SELF-TEST DIAGNOSTIC TROUBLE CODE (DTC) CHART

DTC Description Action
B1432 Wiper Brake/Run Relay Circuit Short to Battery Go to Pinpoint Test A .
B1433 Wiper Brake/Run Relay Circuit Short to Ground Go to Pinpoint Test B .
B1447 Wiper Park Sense Circuit Open Go to Pinpoint Test F .
B2179 Front Wiper Select Switch "A" Short to Ground Go to Pinpoint Test B .
B2180 Front Wiper Select Switch "B" Short to Ground Go to Pinpoint Test B .
B2181 Front Wiper Select Switch "C" Short to Ground Go to Pinpoint Test B .
B2183 Front Wiper Select Switch "H" Short to Ground Go to Pinpoint Test C .
B2184 Front Wiper Select Switch "W" Short to Ground Go to Pinpoint Test E .
U1900 CAN communication bus fault - receive error
NOTE: Do not install a new SJB as part of a repair for a SJB DTC U1900 fault.
The SJB is not the source of the fault when DTC U1900 is present. REFER to MODULE COMMUNICATIONS NETWORK to diagnose the MS-CAN network concern.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.