2007 Ford Focus STFACTORY OEM SERVICE PROCEDURE

External Controls: Function

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating Release Mechanism Cover
GF0039983Courtesy of FORD MOTOR CO.
    NOTE: If PARK is selected again, the selector lever is locked again.
  • If the brake signal should fail due to a malfunction, manual unlocking is possible.
  • The cover of the release mechanism must be removed and a suitable object (ignition key) pressed into the opening until the manual selector lever can be moved out of PARK position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.