2007 Ford Focus STFACTORY OEM SERVICE PROCEDURE

Electronic Engine Controls

The electronic engine controls consist of the:

  • powertrain control module (PCM).
  • throttle position (TP) sensor.
  • idle air control (IAC) valve.
  • cylinder head temperature (CHT) sensor.
  • camshaft position (CMP) sensor.
  • crankshaft position (CKP) sensor.
  • power steering pressure (PSP) switch.
  • mass air flow (MAF) sensor.
  • heated oxygen sensor (HO2S).
  • catalyst monitor sensor(s).
  • knock sensor (KS).
  • fuel rail pressure and temperature sensor.

The PCM:

  • accepts input from various engine sensors to compute the fuel flow rate and spark timing necessary to maintain a prescribed air/fuel ratio throughout the entire engine operating range.
  • outputs a command to the fuel injectors to meter the appropriate quantity of fuel.

The TP sensor:

  • sends the PCM a signal indicating the throttle plate angle.
  • is the main input to the PCM from the driver.

The IAC valve:

  • controls bypass air around the throttle plate at low engine speeds.
  • accommodates for small changes in engine load.
  • is controlled by the PCM.

The CHT sensor:

  • sends the PCM a signal indicating cylinder head temperature.
  • resistance decreases as coolant temperature increases.

The CMP sensor:

  • provides camshaft position information which is used by the PCM for fuel synchronization.

The CKP sensor:

  • sends the PCM a signal indicating crankshaft position.
  • is essential for calculating spark timing.

The PSP switch:

  • is a normally closed switch that opens as pressure increases.
  • is used to send a signal to the PCM to adjust idle speed. This compensates for additional load on the engine from the power steering pump.

The MAF sensor:

  • uses a hot wire sensing element to measure the amount of air entering the engine.
  • uses a second hot wire to measure intake air temperature.
  • sends signals to the PCM. The PCM will then calculate the required fuel injector pulse width in order to provide the desired air/fuel ratio.

The HO2S:

  • has the ability to create a voltage signal dependent on exhaust oxygen content.
  • provides feedback information to the PCM used to calculate fuel delivery.

The catalyst monitor sensor(s):

  • has the ability to create a voltage signal dependent on exhaust oxygen content.
  • provides feedback information to the PCM used to calculate catalyst efficiency.

The KS:

  • sends a signal to the PCM indicating engine detonation, which retards the ignition timing as necessary.

The fuel rail pressure and temperature sensor:

  • measures the pressure and temperature of the fuel rail and sends these signals to the PCM.
  • uses intake manifold vacuum as a pressure reference.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.