Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Focus STFACTORY OEM SERVICE PROCEDURE
Inspection and Verification: Notes
NOTE:
If a new ABS module is installed, it must be configured. REFER to MODULE CONFIGURATION
article.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - Wheel speed sensor
- Hydraulic control unit (HCU)
- Incorrectly inflated tires
- Ford specified steering components, suspension components and tire size
- Wheel speed sensor ring
- Battery junction box (BJB) fuse(s):
- 5 (30A)
- 13 (20A)
- 29 (10A)
- Circuitry
- ABS module
- Traction control switch (if equipped)
- Wheel speed sensor
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
- If the scan tool does not communicate with the VCM:
- check the VCM connection to the vehicle.
- check the scan tool connection to the VCM.
- refer to MODULE COMMUNICATIONS NETWORK article, No power to the scan tool, to diagnose no communication with the scan tool.
- If the scan tool does not communicate with the vehicle:
- verify the ignition key is in the ON position.
- verify the scan tool operation with a known good vehicle.
- refer to MODULE COMMUNICATIONS NETWORK article to diagnose no response from the powertrain control module (PCM).
- Carry out the network test.
- If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK article.
- If the network test passes, retrieve and record continuous memory diagnostic trouble codes (DTCs).
- Clear the continuous DTCs and carry out the self-test diagnostics for the anti-lock brake system (ABS) module.
- If the DTCs retrieved are related to the concern, go to Anti-Lock Brake System (ABS) Module Diagnostic Trouble Code (DTC) IndexΒ . For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES article.
- If no DTCs related to the concern are retrieved, go to Symptom ChartΒ .
NOTE:
Make sure to use the latest scan tool software release.
NOTE:
The vehicle communication module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
