Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Focus L4-2.3L VIN ZFACTORY OEM SERVICE PROCEDURE
Piston, Engine
Piston
Diameter (1) 87.5-87.51 mm (3.444-3.445 inch)
Diameter (2) 87.51-87.52 mm (3.4452-3.4456 inch)
Diameter (3) 87.52-87.53 mm (3.4456-3.4460 inch)
Piston-to-bore clearance 0.025-0.045 mm (0.0009-0.0017 inch)
Ring groove width - top 1.203-1.205 mm (0.0473-0.0474 inch)
Ring groove width - 2nd 1.17-1.19 mm (0.0460-0.0468 inch)
Ring groove width - oil 2.501-2.503 mm (0.0984-0.0985 inch)
Piston skirt coating thickness 0.008-0.020 mm (0.0003-0.0007 inch)
Piston Pin
Diameter 20.995-21.0 mm (0.8265-0.8267 inch)
Length 59.6-60.4 mm (2.346-2.377 inch)
Piston-to-pin clearance 0.008-0.016 mm (0.0003-0.0006 inch)
Pin-to-rod clearance Press fit
Diameter (1) 87.5-87.51 mm (3.444-3.445 inch)
Diameter (2) 87.51-87.52 mm (3.4452-3.4456 inch)
Diameter (3) 87.52-87.53 mm (3.4456-3.4460 inch)
Piston-to-bore clearance 0.025-0.045 mm (0.0009-0.0017 inch)
Ring groove width - top 1.203-1.205 mm (0.0473-0.0474 inch)
Ring groove width - 2nd 1.17-1.19 mm (0.0460-0.0468 inch)
Ring groove width - oil 2.501-2.503 mm (0.0984-0.0985 inch)
Piston skirt coating thickness 0.008-0.020 mm (0.0003-0.0007 inch)
Piston Pin
Diameter 20.995-21.0 mm (0.8265-0.8267 inch)
Length 59.6-60.4 mm (2.346-2.377 inch)
Piston-to-pin clearance 0.008-0.016 mm (0.0003-0.0006 inch)
Pin-to-rod clearance Press fit
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
