2007 Ford Focus L4-2.3L VIN ZFACTORY OEM SERVICE PROCEDURE

Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)


Factory service manual diagram





Removal

1. NOTE: Any PCM replacement will require that ALL customer keys are available to be programmed at the time of installation. PCM replacement DOES NOT require new keys.

Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure.


Factory service manual diagram





2. Remove the instrument panel side trim.


Factory service manual diagram





3. Remove the cowl side trim panel.


Factory service manual diagram





4. Remove the glove compartment.


Factory service manual diagram





5. Remove the passenger side lower footwell trim panel.
6. Remove the 2 generic electronic module (GEM) nuts and position aside.
7. Disconnect the PCM electrical connectors and remove the PCM.

Installation
1. Install the PCM and connect the electrical connectors.

2. CAUTION: Make sure that the PCM electrical connectors do not unlock when installing the GEM module.

Position the GEM module and install the 2 nuts.
- Tighten to 10 Nm (89 lb-in).


Factory service manual diagram





3. Install the passenger side lower footwell trim panel.


Factory service manual diagram





4. Install the glove compartment.


Factory service manual diagram





5. Install the cowl side trim panel.


Factory service manual diagram





6. Install the instrument panel side trim.
7. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure.
8. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.