2007 Ford Focus L4-2.3L VIN ZFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor: Service and Repair

THROTTLE POSITION (TP) SENSOR


Factory service manual diagram





Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the throttle position (TP) sensor electrical connector.
3. Remove the 2 TP sensor retaining screws and the TP sensor.
- To install, tighten to 10 Nm (89 lb-in).

4. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.