Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Focus L4-2.3L VIN ZFACTORY OEM SERVICE PROCEDURE
Catalyst Monitor Sensor
CATALYST MONITOR SENSOR

Exploded View
Removal and Installation
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Unsnap the electrical connector heat shield.
Vehicles with secondary air injection

4. Disconnect the electrical connectors and detach the wiring retainers.
5. NOTE: If necessary, lubricate the catalyst monitor sensors (CMS) with penetrating and lock lubricant to assist in removal.
Using a 22-mm crowfoot wrench, remove the CMS.
- To install, tighten to 48 Nm (35 lb-ft).
Vehicles without secondary air injection

6. Disconnect the electrical connector and detach the wiring retainer.
7. NOTE: If necessary, lubricate the catalyst monitor sensor with penetrating and lock lubricant to assist in removal.
Using a 22-mm crowfoot wrench, remove the CMS.
- To install, tighten to 48 Nm (35 lb-ft).
All vehicles
8. CAUTION:
- Make sure that the electrical connector locking tab is engaged.
- Make sure that the sensor wiring is secured with all retainers and routed away from hot surfaces and sharp edges.
NOTE: Make sure to apply anti-seize lubricant to the threads of the sensors before installation.
To install, reverse the removal procedure.
Exploded View
Removal and Installation
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Unsnap the electrical connector heat shield.
Vehicles with secondary air injection
4. Disconnect the electrical connectors and detach the wiring retainers.
5. NOTE: If necessary, lubricate the catalyst monitor sensors (CMS) with penetrating and lock lubricant to assist in removal.
Using a 22-mm crowfoot wrench, remove the CMS.
- To install, tighten to 48 Nm (35 lb-ft).
Vehicles without secondary air injection
6. Disconnect the electrical connector and detach the wiring retainer.
7. NOTE: If necessary, lubricate the catalyst monitor sensor with penetrating and lock lubricant to assist in removal.
Using a 22-mm crowfoot wrench, remove the CMS.
- To install, tighten to 48 Nm (35 lb-ft).
All vehicles
8. CAUTION:
- Make sure that the electrical connector locking tab is engaged.
- Make sure that the sensor wiring is secured with all retainers and routed away from hot surfaces and sharp edges.
NOTE: Make sure to apply anti-seize lubricant to the threads of the sensors before installation.
To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
