2007 Ford Focus L4-2.3L VIN ZFACTORY OEM SERVICE PROCEDURE

Air Flow Meter/Sensor: Service and Repair

MASS AIR FLOW (MAF) SENSOR


Factory service manual diagram





Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Disconnect the mass air flow (MAF) sensor electrical connector.
4. Remove the 2 MAF sensor retaining screws and the MAF sensor.
- To install, tighten to 10 Nm (89 lb-in).

5. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.