Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Focus L4-2.3L VIN ZFACTORY OEM SERVICE PROCEDURE
Temperature Control Switch
TEMPERATURE CONTROL SWITCH
Removal and Installation

1. Remove the 4 bolts and position aside the lower steering column cover.
2. Remove the temperature control knob.

3. Remove the center instrument panel finish panel.
- Disconnect the cigar lighter electrical connector.

4. Remove the screw and detach the temperature control switch.

5. Detach the temperature control cable and remove the temperature selector cable assembly.
6. To install, reverse the removal procedure.
Removal and Installation
1. Remove the 4 bolts and position aside the lower steering column cover.
2. Remove the temperature control knob.
3. Remove the center instrument panel finish panel.
- Disconnect the cigar lighter electrical connector.
4. Remove the screw and detach the temperature control switch.
5. Detach the temperature control cable and remove the temperature selector cable assembly.
6. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
