Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Explorer 4.6 8, RWDFACTORY OEM SERVICE PROCEDURE
Safety Belt System
- Specifications
- Description And Operation
- Safety Belt System
- Notes
- Safety Belt Buckle and Pretensioner
- Safety Belt Adaptive Load Limiting Retractor
- Dual Locking Mode Retractors
- Energy Management Retractor
- Safety Belt Extension Assembly
- Child Safety Seat Tether Anchors
- Attaching Safety Seats With Tether Straps
- Lower Anchors and Tethers for Children (LATCH)
- Safety Belt Warning Indicator and Chime
- Belt Minder
- Safety Belt System
- Diagnostic Tests
- General Procedures
- Removal And Installation
- Child Safety Seat Tether Anchor - Second Row
- Child Safety Seat Tether Anchor - Third Row
- Safety Belt Buckle - Second Row, Bucket
- Safety Belt Buckle - Second Row, Center and RH, 60/40, Bench
- Safety Belt Buckle - Second Row, Center and RH, 60/40, E-Z Entry
- Safety Belt Buckle - Second Row, LH, 60/40, Bench
- Safety Belt Buckle - Second Row, LH, 60/40, E-Z Entry
- Safety Belt Buckle - Third Row
- Safety Belt Buckle and Pretensioner
- Safety Belt Retractor - Front
- Safety Belt Retractor - Second Row, Center, 60/40, Bench
- Safety Belt Retractor - Second Row, Center, 60/40, E-Z Entry
- Safety Belt Retractor - Second Row, Outboard
- Safety Belt Retractor - Third Row
- Safety Belt Shoulder Height Adjuster
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.