Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, FWDFACTORY OEM SERVICE PROCEDURE
Automatic Transmission: Removal: Transaxle: Notes
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Adapters for 303-290A | 303-290A-01 | |
| Adapter for 303-290A (Lifting Hook) | 303-290A-12 | |
| Adapter for 303-290A (Support Leg) | 303-290A-03A | |
| Adapter, Transmission Jack | 209-00152 | |
| Bearing Cup Puller | 308-047 (T77F-1102-A) | |
| Disconnect Tool, Transmission Cooler Line | 307-569 | |
| Engine Lifting Bracket | 303-1245 | |
| Remover, Front Wheel Hub | 205-D070 (D93P-1175-B) or equivalent | |
| Remover, Halfshaft | 205-241 (T89P-3514-A) | |
| Remover, Halfshaft (Plate) | 205-290 (T89P-3415-B) | |
| Slide Hammer | 100-001 (T50T-100-A) | |
| Spreader Bar | 303-1246 | |
| Support Bar, Engine | 303-290A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.