Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, FWDFACTORY OEM SERVICE PROCEDURE
Automatic Transmission: Installation: Transaxle: Notes
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Adapters for 303-290A | 303-290A-01 | |
| Adapter for 303-290A (Lifting Hook) | 303-290A-12 | |
| Adapter for 303-290A (Support Leg) | 303-290A-03A | |
| Adapter, Transmission Jack | 209-00152 | |
| Engine Lifting Bracket | 303-1245 | |
| Heat Gun | 107-R0300 | |
| Installer, Halfshaft Oil Seal | 308-431 | |
| Installer, PTU Drive Gear Outer Oil Seal | 308-430 | |
| Spreader Bar | 303-1246 | |
| Support Bar, Engine | 303-290A |
Material
| Item | Specification |
|---|---|
| MERCON® V Automatic Transmission Fluid XT-5-QM (or XT-5-QMC) (US); CXT-5-LM12 (Canada) |
MERCON® V |
| Multi-Purpose Grease XG-4 and/or XL-5 |
ESB-M1C93-B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.